V2.4

Raspberry Pi 7inch Display Mount

by revnull
Raspberry Pi 7inch Display Mount
An articulating mount for the offical Raspberry Pi 7inch touch screen
2021-07-06T12:05:32
1196
GPL v3.0
Images
cable_flat.jpg
cable_vertical.jpg
display_flat.jpg
display_front.jpg
display_tilted.jpg
display_vertical.jpg
mount_flat.jpg
mount_vertical.jpg
README.md
STL
swing_arm_lg_a.stl
swing_arm_lg_b.stl
swing_arm_sm_x2.stl
voron_2.4_7in_pi_base.stl
voron_2.4_lcd_mount_foot_a.stl
voron_2.4_lcd_mount_foot_b.stl

Articulating Raspberry Pi 7" Display Mount

Image

This is a combo remix of driftology's awesome articulating mount for the Paneldue 7i V3 and th3fallen's PITFT50 mounting plate. It enables the official Raspberry Pi 7" touchscreen display to be mounted in place of spec LCD to run KlipperScreen while allowing the screen to tile out of the way to open and close the doors when needed.

Image Image Image

Installation:

Parts:

  • Raspberry Pi Touch Display
  • Flex Ribbon Extension Cable (length depending on distance from Pi)
  • 8 x M3x8 (SHCS)
  • 2 x M4x8 (SHCS)
  • 2 x M4 T/Hammer Nuts
  • Zip ties

Optional Display Case Back:

Assemble the parts in the following orientation making sure not to overtighten or strip the screw holes. The movement should be smooth, but tight enough to hold position. Image Image

Route the ribbon cable through cutout in the center of the mounting plate and up and over the pivot points. Use zip ties to secure the cables in place ensuring there is no binding in either position. Image Image

© 2023Voron Design.All rights reserved.