V2.4

Sturdy Handles

by jeoje
Sturdy Handles
Modified v2.2 handles with no panel rest and with 4 anchor points
2021-05-08T00:16:10
2003
GPL v3.0
CAD
sturdy_handles.f3d
sturdy_handles.step
README.md
STL
sturdy_handles.stl
images
offset_profile.png
photo.png
side_profile.png

Voron v2.4 Sturdy Handles

I wanted handles for the v2.4 that were a bit more sturdy than I've been able to find and that didn't act as a clip for the panels. That's what I have the clips for :). This is a modified v2.2 handle that has 4 anchor points. It will not work on the bottom extrusions if you're using skirts, but should anywhere that has access to 2 adjacent sides of an extrusion. It has 6mm of clearance on the side that will go over the panel slightly.

Parts Required

PartQuantityComment
M5 X 12 SHCS2
M5 T-Nut2

Printing

  • Print using standard Voron part settings and in the orientation used in the STL
  • Supports should not be needed, but the overhang is < 45 degrees. That area is hidden from view and tolerances don't really matter there. Regardless, it prints clean for me.

Installation

  • You will likely need to move the top panel out of the way for installation. I just removed clips from one side and the middle to lift it up a bit.
© 2023Voron Design.All rights reserved.