V0

3mm Top Hat Panels Clips

LoCoCNC

Required to use the 3mm (1/8") thick top hat panels for V0.1
    Front_and_Rear_Midclip_3mm_Panels_x2.stl
    Left_and_Right_Midclip_3mm_Panels_x2.stl
    Lower_Corner_1_and_3_Clip_3mm_Panels_x2.stl
    Lower_Corner_2_and_4_Clip_3mm_Panels_x2.stl
    Readme.md
    Upper_Corner_1_and_3_Clip_3mm_Panels_x2.stl
    Upper_Corner_2_and_4_Clip_3mm_Panels_x2.stl

Select a file to view it.

Printed Solid sells 1/8" (3mm+), these do not work with the spec parts. I modifed all the "clamps" to accommodate 1.5mm extra (you can then shim as needed, I did not have to after carefully deburring all parts) Printed and Tested! Makes the assembly actually fit on the printer as intended perfectly.

© 2024Voron Design.All rights reserved.