V2.4

Z Belt Clip

ChenTheDesignMaker

Simple clip to keep extra Z belts clean and away from panels
    imgs
      IMG_3018.jpg
      IMG_3019.jpg
      IMG_3020.jpg
    .metadata.yml
    README.md
    z_belt_clipX4.stl

Select a file to view it.

What is this?

A simple Z belt clip

The 2.4 manual suggested leaving 1 to 2 inch Z belts, however, when the panels are up, the extra belt can drag along the panel. Not sure about adversary effects but not a bad idea to keep it tidy. The clip works for 9mm width belts, also should fit 6 mm. Just print and slide on.

Extra belts before panel Extra belts before panel

Extra belts with panel Extra belts with panel

Installed Clip, all cleaned up! Installed Clip, all cleaned up!

© 2024Voron Design.All rights reserved.