Angry CAM USB
by chri.kai.in
Housing for small USB camera module, allowing mounting to gantry or frame profiles
- V2
14,189 views1,218 downloads
Legacy area
- V2.1
- V2.2
Low Profile Exhaust Duct
by chilicoke
v1 · source 8e5067f · 8 files
Quick-release exhaust duct adapter that requires minumal rear spacing
0 views0 downloads
Images
This mod is in the legacy area of Voron Users (for older printer designs) and may not be maintained.
Files
STL models (5)
Documents (1)
Documents: Show or hide 1 file
- README.mdMD721 BDownload
README
Low Profile Exhaust Duct Adapter
This adapter allows you to fit 4" flexable dryer duct to your 120mm exhaust fan with minimal rear protrusion. It is quick release held on with magnets.
Part needs to be assumbled with super glue, also requires minimum 8 6x4mm disk magnets for the quick release. Multiple thinner magents can also be used if stacked together for additional pull strength. Holes for magnets should be pressed fit if printed with .4mm nozzle, Mine were printed with .8 and they needed to be reamed for a good fit.
You will also need to replace the 4x fan screws with longer M3x35 SHCS.
Related mods
Belt Tension Meter
by Kruppes
Print in place tension meter to easily tighten multiple belts to the same tension- V0
- V1
- V2
- VSW
9,343 views1,131 downloads
Printable snap latches for 2020 extrusion
by richardjm
Quick release panel latch inspired by the work of others.- V2
12,147 views1,681 downloads
Voron2.4 and Trident Pins Mod
by hartk1213
This mod replaces all the M5 screws for all idlers/pulleys/bearings with 5mm pins- V2
- VT
12,922 views1,138 downloads
20x20mm Profile Covers
by chri.kai.in
Provide overlapping and flush slot covers for 20x20mm slot6 construction profiles- V1
- V2
- VSW
- VT
5,449 views944 downloads
Extrusion/Chamber Thermistor Mount
by samwiseg0
Extrusion mount for a NTC100K Thermistor extrusion- V0
- V1
- V2
- VSW
- VT
4,606 views819 downloads