Legacy area
- V2.2
Openbuilds Drag Chain 2.2
v1 · source 8e5067f · 10 files
Off-the-shelf, cheap, snap opening drag chain for gantry wiring and protecting wires down to the deck
0 views0 downloads
Images
This mod is in the legacy area of Voron Users (for older printer designs) and may not be maintained.
Files
STL models (6)
CAD files (1)
CAD files: Show or hide 1 file
- 2.2_cable_chain_v26.stepSTEP700 kBDownload
Documents (1)
Documents: Show or hide 1 file
- README.mdMD1.3 kBDownload
README
Off The Shelf Drag Chains for 2.2
Why
- Drag chains with a snap open side are a joy to work on.
- It looks awesome.
- I hate printing chains for myself and these are cheap.
BOM
- Some M3x6 screws
- Some M3 nuts
- A few M5 screws that are a couple millimeters longer than the M5's on the gantry. You'll figure it out.
- 3x Openbuilds 10x15mm 18mm radius Drag Chains
STLs
| File | Note |
|---|---|
| x_carriage_mount | You screw your drag chain's floppy end to this side. You might need the +10mm version, print both just in case. |
| xy_bridge | You screw your drag chain's floppy end to this side. Wires go through it and up into the Y chain. |
| a_corner_tube | Keeps your wires from touching the rail, frame, side covers and belt. |
| upper_z_mount | You screw your drag chain's floppy end to this side. This holds a_corner_tube |
| lower_z_mount | Mounts to the rear lower frame. You'll need to cut an L shaped slot into your bottom panel. Also a great spot to run your bed and heater wires down through. Move this on the rail until you get a little tension on your Z chain. That'll keep it tight and it will look awesome. |
Known Issues
- None
Related mods
Direct Drive BMG-m mount
Open toolhead mounting plans for Bondtech BMG-m and Mosquito direct drive comboLegacy area- V2
0 views0 downloads
Openbuilds Drag Chain 2.1
Off-the-shelf, cheap, snap opening drag chain for gantry wiring and protecting wires down to the deckLegacy area- V2
0 views0 downloads
Angry CAM USB
by chri.kai.in
Housing for small USB camera module, allowing mounting to gantry or frame profiles- V2
14,189 views1,218 downloads
Belt Tension Meter
by Kruppes
Print in place tension meter to easily tighten multiple belts to the same tension- V0
- V1
- V2
- VSW
9,343 views1,131 downloads
Printable snap latches for 2020 extrusion
by richardjm
Quick release panel latch inspired by the work of others.- V2
12,147 views1,681 downloads