Voron 2.4 Pull-out electrical Store 中文说明

Important Notice

Only aimed at Voron V2.4 350mm printer now.
This MOD is based on V2.4R1 and may not be perfectly compatible with V2.4R2

• Due to the need to ensure a smooth drawer out, after using this MOD will reduce the space of the electrical store, please check the below table find the available space.

Printer spec	Inner space	Available space
350mm	470 * 285 * 77	470 * 257 * 60
300mm	420 * 235 * 77	420 * 207 * 60
250mm	370 * 185 * 77	370 * 157 * 60

• You will need about 30 metres of additional wire to connect the drawers.

Please use it according to the actual situation.

Objectives

The objectives for this project are:

• Easily to open the electrical bin for debugging

Overall

Picture

Video

https://www.youtube.com/embed/usf8aM6o3Y0

https://www.youtube.com/embed/9XUpTigEtQ4

3D Model

https://evercraft.co/share?key=E561A9

Bill of Materials (BOM)

Category	Part Name	QTY	Remark
Printed Parts	Mini12864_Case	X1
Printed Parts	Front panel L	X1
Printed Parts	Front panel R	X1
Printed Parts	Fan_decorative_panel	X2
Printed Parts	Side panel L	X1	Option Incompatible with v2.4r2
Printed Parts	Side panel R	X1	Option Incompatible with v2.4r2
Panels	Bottom_plate	X1	AS the Drawing*
Panels	Drawer_sides	X2	AS the Drawing*
Panels	Drawer_Support	X2	AS the Drawing*
Panels	Reinforcing_rib	X4	AS the Drawing*
Motion	450mm Guide_rail	X1Pair
Cables	Cable Chain	X1	10*20(Inner H x Inner W) (R18max)
Cables	24AWG Silicone Cable	X26M	Additional
Cables	20AWG Silicone Cable	X4M	Additional
Hardware	STEEL CORNER	X8
Fasteners	M3x40 SHCS	X2
Fasteners	M3 Threaded Insert	X4	M3X5X4
Fasteners	M3*20 Self-tapping Screw	X22
Fasteners	M3*10 Self-tapping Screw	X16
Fasteners	M5*10 Self-tapping Screw	X8
Fasteners	M5*6 BHCS	X8
Fasteners	M5 1mm Spacer	X8
Fasteners	M5 T-nut	X8	HNTAJ5-5
Electronics	60x60x15 Fan	X2

*You can use any type of sheet, epoxy sheet is recommended.

Briefly instructions

Donate

You want to donate something regarding this project? No, you can't. :)