Mounts the PSU vertically on the DIN rails

A direct drive mod for the V0 using the Annex Sherpa Mini extruder

V0 skirts with small loops added along the top to allow zip tyiing cables to them

Mod for a centered cable management

PlugPanel with Options for 3 Keystones

New rear panels designed to expose the extruder for easy filament swapping

Add MGN12H linear rails for Z axis motion

Basic LED mounts for 10 and 12mm strips

V2 panel corner frames using 3-way L brackets in the corners

A bracket for TL filament sensor to mount near stock spool holder.

Simple jig for cutting and grinding 60mm Z shafts

A MGN-12 carriage with an inset mount for a Euclid Probe

Another style V0 skirt

V0.1 Motor panel modification to keep umbilical and bowden tube from rubbing against motor belts

A replacement strain relief for the Mini Afterburner toolhead

A replacement Front Bed Mount with room for a neopixel or dotstar behind the logo

100mm/4" ducting mount for ventilation. Also supports umbilical cord and has 3 orientations for bowden adapter.

Huvud rear mount for Clockwork or LGX that supports a cable chain.

V0 Mount for a ADXL345 module

Middle Skirt for V2-200mm² Electronics Compartment

A simple DIN rail mount for the Adafruit (or SAME SIZE clone) MAX31865 PT100 Board.

This mod allows the use of different smartphones or possibly tablets that you may want to use for klipperscreen.

v2.4 plug panel for generic unfiltered modules with 66mm x 27mm cutout such as the Delta 06A2 and Qualtek 761-18

Tophat Extractor for the Voron V0.1 with activated charcoal and HEPA filter