Skirt-mounted rocker switch for easy access for Voron 2.4

A toolhead mount for a dial test indicator, where the tip is located at the nozzle.

Skirts for a 320mm build

A cable comb for simplifying and tidying wire harnesses for printers with drag chains

Mount for pi camera and ZeroW

PlugPanel with Options for 3 Keystones

Z Carriage Stop modification that makes pass through of wires for the LED light bar clean and easy

v2.4 plug panel for generic unfiltered modules with 66mm x 27mm cutout such as the Delta 06A2 and Qualtek 761-18

Permanent mount for ADXL boards on the back of the motor, replacing the drag chain mount.

Aplic HD camera to the 2020 frame at bed level.

Shims for making bearing cartridges coplanar

Mod to mount a 4 channel GPIO controlled relay

Attaching DIN Rails to 2020

Duet wifi mount in pocketwatch location

A mount for 10mm LED strips and Exhaust for Voron V0

Mod to mount a M4 extruder to a Voron 0 where pocketwatch extruder mounts

A LED lightbar for switchwire

SKR V1.3 bracket turned 90 degrees

A bracket for TL filament sensor to mount near stock spool holder.

Pi Zero mount over a Duet2 for space saving

V0 skirts with small loops added along the top to allow zip tyiing cables to them

A modified plug panel for Voron 2.4r1 with Schurter CD44.1101.151 power entry modul. The panel has a LAN socket as well.

A side mounting for a CAN board (Huvud/SHT42) to the LGX Lite

New rear panels designed to expose the extruder for easy filament swapping