Replace the 2.4 stock bowden tube holder and add a filament runout sensor

Shorter Z joints for the v2.4

Wrench for easier turning of the belt tension knobs on V0.1

Wire management for the v2 bed

Printable and openable 10x11mm chain

Exhaust housing with dual cover screws and single or dual side entry filament paths.

An adjustable umbilical collar for the stock motor panel on the V0

Slim mount for logitech c920 webcam

Voron Parts Logo for your back panels, 3D Print or Laser Cut

MGN9C linear rail for the X axis on V0.2

Mounting brackets for the klipper expander using vhb tape or mounting screws

Back blanking plate that can be used instead of the exhaust filter housing if you are using something like a nevermore filter instead.

Mount for the BTT PiTFT Touchscreen

Mounts a [Waveshare 4.3inch Capacitive Touch Display](https://www.waveshare.com/4.3inch-dsi-lcd.htm) to v2.4 and Switchwire Vorons

An articulating mount for the offical Raspberry Pi 7inch touch screen

A Reverse Bowden Inlet for the upper-rear panel of the Voron Zero with an optional filament sensor.

Low profile raspberry pi camera mount

v2.4 magnetic clips to retain bottom panel

Clip-on frame to stiffen and seal front door panels when using modified hinges.

A modification that allow lubrication of the linear reals while fully assembled.

Juiced up skirts for the V0.2

A way of reaching electronics from the top by having a "car hood" style hinge for the heatbed, and rotated electronics mounts.

Energychain for V2.4

Skirt pieces for Trident, 2.4 and 2.4r2 for combo inlets in 2 sizes.