A purely cosmetic mod for Afterburner

Added keystone slot on rear skirt for V0.2

Permanent mount for ADXL boards on the back of the motor, replacing the drag chain mount.

Switchwie Y axis Belt Tensioner

Skirt power panel for generic amazon plug/switch/fuse combo module, with 2 keystone sockets

Low profile raspberry pi camera mount

Voron0 MidPanel with Hex pattern and Wire cover

Small mods to belt routing components to ensure a better/more robust alignment

Added a new Power inlet that uses a Fused C14 plug and switch that covers the mains contacts

A holder to attach Neopixel/WS2812B Led Strips to the V0.1

Din carrier for a Corsair Flash Voyager GTX

Covers both the original Phaetus variant as well as the Zodiac one.

Simple mod of print in place door hinges, which uses m3 screws as shafts.

Trident style side power inlet for V2.4 using Z Drive Motor Tensioner Mod - By @Amarpal89

v2.4 Exhaust Housing for 120mm Fan and 4in Duct

Top panel with magnets allows for quick installation and removal

Filter case with fan´s

Electronics cooling solution for Voron Zero

New idler uppers for MGN9 Extrusion backers

Drawer in four different versions

an RGB-Powered front-bed mount for the Voron V0 with Kirigami Bed Frame

Spool holder where the length is a parameter.

Runout UnKlicky Sensor is a filament runout sensor with mounts for 1515 and 2020 extrusions

A Fanless alternative middle side skirt