V2.4

Display mount 5"

by Tircown
Display mount 5"
Tiltable mount for a 5" tactile display
2022-04-07T01:45:43
1076
GPL v3.0
Images
Capture.JPG
image0.jpg
image1.jpg
image3.jpg
README.md
display5inch_arm_a.stl
display5inch_arm_b.stl
display5inch_case.stl
display5inch_case_moretolerance.stl
display5inch_front_rear_skirt_a_250.stl
display5inch_front_rear_skirt_a_300.stl
display5inch_front_rear_skirt_a_350.stl
display5inch_front_rear_skirt_b_250.stl
display5inch_front_rear_skirt_b_300.stl
display5inch_front_rear_skirt_b_350.stl
display5inch_optional_microsd_holder.stl
display5inch_optional_sd_holder.stl
display5inch_slide_x2.stl

Voron 2.4 5" display tilting support

Many thanks to Jo_Thingiverse for having tested this mount.

Bill Of Materials

  • Screen 5" 800*480 IPS TFT MIPI DSI Multi-Touch Capacitive Touch Panel LCD Module Display Monitor Screen for Raspberry Pi
  • optional SD extender or microSD extender
  • 2 M3x15
  • 6(+4) M3x8
  • 6 M3 threaded inserts
  • 2 M3 hammered nuts

Instructions

  1. Put one M3 threaded insert in each arm end.
  2. Put four M3 threaded insert in the back of the screen case.
  3. Remove the built-in support in the fork of both arms.
  4. Install the two slides with M3x8.
  5. Use two pieces of filament as hinges.
  6. Adjust the tension of the screws that pass through the slides to keep the position.
  7. The optional installation of the SD extender requires four self tapping M3x8.

Since the screen is larger than the original piece you will have to replace your sides skirts. These are included too.

CAD photo1 photo2 photo3

© 2023Voron Design.All rights reserved.