Quick release panel latch inspired by the work of others.

This mod replaces all the M5 screws for all idlers/pulleys/bearings with 5mm pins

Print in place tension meter to easily tighten multiple belts to the same tension

Flip the Trident electronics bay for top access.

Housing for small USB camera module, allowing mounting to gantry or frame profiles

Mod for the Ender 3 and Ender 3 Pro, which adapts the kinematics and most other parts of the Voron Switchwire.

Handle for Voron 2.4

This mod replaces the stack of printed z joints with a metal spherical bearing

Stop for positioning your PEI

Simple clip to keep extra Z belts clean and away from panels

Rockers to roll the printer on its back for easier access to the electronics compartment

Extrusion mount for a NTC100K Thermistor extrusion

New hinge to easily remove the door and have a wide opening V2.x

Zip tie mount intergrated cable duct to hide your cable

Bed fan control macros and 5015 bed fan mounts

Wago Mounts for Din Rail or 2020 Extrusion mounting.

For any cutting machines or machines that rely on vector graphics and use .svg files. These vectors or .svg files are the Voron Design Logos for the Voron 2.4, Voron SwitchWire, Voron 0.0/0.1. and Trident These .svg files use a minimal amount of anchor points to achieve the vector shapes!

Microswitch based inductive probe replacement

A jig help align extrusions to get a properly square frame

Provide overlapping and flush slot covers for 20x20mm slot6 construction profiles

Voron 2.4 door hinges for 3mm panel, 180 deg opening and m3 screw as shaft

Bowden tube guide and CANBUS wire support

Z belt covers that allow hidden cable routing.

Rear Umbilical mounting solution including a relocated Y-Endstop